Cobra Racing full Aluminum Caster Block, Steering Block and Rear Axle Stub carrier (Full combo in red fully assembled). This will directly replace your stock parts with much beefier aluminum parts that are guaranteed to never break on you. Not to mention these parts will greatly enhance the look and driveability of your car. Since these parts are made of Aluminum, there will be no more flex when you do sharp turns. So you will notice that everything just feels more tighter, and more enjoyable to drive.
Compatible with:
Traxxas Slash 4×4 VXL / Ultimate / Platinum
Traxxas Rustler 4×4 VXL
Traxxas Hoss 4×4 VXL
Traxxas Stampede 4×4 VXL
Please note: Not for use on 2wd Slash or 2wd Stampede!
What’s included in package:
Two steering blocks (Right and Left)
Two Caster Blocks (Right and Left)
Two rear axle hub carrier (Right and Left)
8 total rubber sealed bearings for full install.
Important Notes
-
Recommended: Use thread locker on all connection points (especially where you have metal on metal, aluminum on metal or aluminum on aluminum). Not using thread locker may cause screws to back out mid-run, potentially leading to damage or loss of parts.
-
These knuckles and hubs use standard 5mm knuckle sizes. They are not compatible on an EHD setups (Extreme Heavy Duty), which uses 6mm bearings.
-
Before purchasing, double-check that your vehicle uses standard 5mm knuckles (which is going to be the vast majority of trucks out there). If unsure, compare your current knuckles and hubs to the product pictures carefully to confirm compatibility. There will be slight differences as our designs are not the same. But the EHD knuckles will look a lot different than standard knuckles.
Reviews
There are no reviews yet